1981 Honda Cx500 Scrambler/Racer

Sprint week is over and there’s only that much you can do. Seems and feels like nothing but i had some criticals done. See you next summer with this one✌️

14 chispas

Hace 4 años

Made a new tunnel. That paper thin wall was PAIN to weld...

6 chispas

Matti lyytikäinen

I tig weld it with Esab Byddy160.

Ashley carter

Did you gas weld them? My chop was like that... I tried mig, then Tig, then finally worked out that gas was key...

Ver los 2 comentarios

Hace 4 años

Unfortunately i was not able to fire it up because bad coils. Due to that i had time to do some rear frame fabrication and i think i fucked up. Seat is sagging over the rear loop 🤦🏻‍♂️. Am i too sensitive?

8 chispas

Hace 4 años

Greetings from lapland ✌️ I made my choice about the fuel tank. With this setup the fitment between tank and seat is gonnabe perfect..

8 chispas

Hace 4 años

This is where i left last time. Lowered the 71 cb tank 2” to fit over the engine. I’m not sure about it... i’m heading back to the garage far a way tomorrow. Trying to get it running 😮.

12 chispas

Hace 4 años