I have made new seat base plate and it took a lot of time and work to fit it perfectly with the gas tank and the tail. Now I gave it to the upholsterer and it should be finished tommorow. #excited #seat

0 sparks

3 days ago

A lot of work it was with the gas tank. It was new, and now I think that much less work it could be with the tank if it was old and even little crashed. The old one has a lot of small inequalities and I had to putty that about 10 times to finally get all surfaces really smooth. Now its primer painted and awaits for the finish paint work. It will be silver 😃

1 spark

3 days ago

I was looking for some possibilities with the front fender and at the end I decided to trim the original fender. That was a good idea, because now the fender fits perfectly 👌 Only new paint on it and its done 😃

0 sparks

3 days ago

For the rear light all is prepared now, only waiting for the fresh paint to attach the led lights and the covers. Inside are three small taillights which will be covered by a transparent 3D printed cover and smoked plexiglass on it ☺️

0 sparks

3 days ago

Ok, after more than one year of break with the building, started again with the start of this Year. So after one month of work on that, there is huge hope that I will finish to the season! Here is how I wrapped the original headlight

0 sparks

3 days ago