Front fork back together, also a start on the wiring diagram.

5 gnister

For 2 år siden

Took a little side trip apart from the sandblasting and painting. As all the aluminium parst are in a terible state.....with a lot of standing and polishing i archieved a mirror like finish :) still like 10 parts to do the same with

3 gnister

For 3 år siden

Did a first run with the spraypaint gun, now the frame is covered in a nice layer of "avus black". Its been a while but had to upgrade the compressor, build a diy paintbooth and wait for the weather to improve......the end result i would say 7/10, obvious some parts that need touch up or sanding but what a improvement. Next in line for painting are the rims, headlight and maybe the forklegs qll need to be sandblasted first.

4 gnister

For 3 år siden

After a sandblast marathon of 1,5 hour the frame and driveshaft have been coaten wit epoxy primer. Somewhere in spring i'm gonne try to spraypaint it in avus black

2 gnister

For 3 år siden

Did my first run with the homegarage sandblast cabinet. Parts where covered in two layers of paint, oxidation and dirt. Manager to clean 80-90% of the surface especialy the valvecover is hard to fully clean. So still some work to be done. Also the corund blastmedia is a bit to agressieve so gone try a finer grit.

5 gnister

For 3 år siden